Prior to 2007

• 1). Park the Honda ATV and shut off the engine.
  
  
• 2). Remove the screw securing the rear light cover cap located on the back side of the tail light assembly using a Phillips screwdriver.
  
  
• 3). Pull the rear light cover cap directly off to remove it. The bulb socket is beneath the cover.
  
  
• 4). Turn the socket counterclockwise and pull it directly out of the slot to remove the socket from the assembly.
  
  
• 5). Press the bulb toward the socket and turn it counterclockwise to remove the bulb from the socket.
  
  
• 6). Install a new 12-volt 30/30 W x 2 bulb into the socket. Press the bulb toward the socket and turn clockwise to secure.
  
  
• 7). Reinstall the bulb socket into the tail light assembly, lining up the pins on the inner ring of the socket with the slots in the tail light assembly. Turn it clockwise to secure the bulb socket in the assembly.
  
  
• 8). Replace the rear light cover cap and secure it using the Phillips screw you removed earlier.
  
  

2007 to Current

• 1). Open the storage box lid on the rear of the Honda ATV.
  
  
• 2). Push the rear light assembly outward from within the storage box lid until you can access the black connector (3P connector) behind the light assembly. You must push firmly as the light assembly has rubber pins that must be disengaged from the rubber grommets on the inner ring of the light assembly slot.
  
  
• 3). Depress the clip on the 3P connector and disconnect it. Discard the old light assembly.
  
  
• 4). Connect the 3P connector on the new LED light assembly to the connector within the storage box lid.
  
  
• 5). Insert the new light assembly into the slot in the storage box lid, lining up the pins at the top of the unit with the grommets on the inner edge of the slot. Press in until secure and close the storage box lid.