How to Assemble a Weed Eater Handle

104 22
    • 1). Find the three holes on the Weed Eater shaft 12 inches down from the front of the motor. These are the adjustment holes for the handle.

    • 2). Hold the handle from the top and push the half circle portion over the trimmer shaft, lining up the holes on the handle with one set of holes on the shaft.

    • 3). Insert the threaded bolt through the side of the handle with the square hole. The bottom of the bolt head has a square and fits into the hole.

    • 4). Place the flat washer over the end of the bolt on the other side of the handle.Thread the wing nut on the end of the bolt until it is hand tight and the handle is secure. The wing nut does not require a wrench for tightening

Subscribe to our newsletter
Sign up here to get the latest news, updates and special offers delivered directly to your inbox.
You can unsubscribe at any time

Leave A Reply

Your email address will not be published.