How to Bleed the ABS Brake on a Suzuki Grand Vitara
- 1). Ensure that engine switch is turned to the "Off" position.
- 2). Pour brake fluid into the master cylinder reservoir. The master cylinder is a white, squared reservoir with a black cap, located in the area of the engine on the driver side, near the windshield. Ensure that the master cylinder reservoir remains at least half full during the bleeding process.
- 3). Remove the bleeder plug cap (see resources), and immediately attach one end of the vinyl tube to the bleeder plug. Place the other end of the vinyl tube into the bucket.
- 4). Ask a friend to sit in the car to depress the brake. Depress the brake several times in a row.
- 5). Loosen the bleeder plug one-third to one-half turn with a wrench while the brake is depressed. This will cause brake fluid to squirt out into the tube and then into the bucket. Each time you are ready to turn the bleeder plug, ask your friend to depress the brake. Ensure that the brake fluid reservoir remains at least half full during this process to avoid air getting back into the brake line.
- 6). Listen for air bubbles during the process. When you no longer hear bubbles, ask your friend to depress and hold the brake. Tighten the the bleeder plug using a wrench.
- 7). Re-attach the bleeder plug cap. Apply fluid pressure to the pipe line, by depressing the brake pedal, while checking for leakage.
- 8). Fill the brake fluid reservoir with brake fluid to the specified level. Check the brakes for firmness. The brake pressure should not be too soft.