How to Install an Adjustable Line Output Converter

104 22
    • 1). Locate the grey and green speaker wires protruding from the back of the factory car stereo.

    • 2). Snip the speaker wires half way from the back of the stereo. Strip 1/2 inch of insulation from these leads.

    • 3). Pull off the pre-stripped tips of the wires on the line out converter. Crimp a barrel connector on each of these wires.

    • 4). Insert the wires from the factory car stereo into the other end of the crimp connectors. Secure these with the crimp tool.

    • 5). Connect the RCA output of the line out converter to the amplifier. Turn the gain of the amp all the way down, as well as the gains on the converter.

    • 6). Turn the volume of the stereo up to 3/4 volume. Slowly increase the output of the converter until the volume is at a clean, undistorted level. If the output remains too low at max output from the converter, slowly increase gain at the amp.

Subscribe to our newsletter
Sign up here to get the latest news, updates and special offers delivered directly to your inbox.
You can unsubscribe at any time

Leave A Reply

Your email address will not be published.